The QSC PLX-2402 comes from a line of amplifiers that defines high impact. It delivers up to 3,400 watts in a two rack-unit chassis that’s only 13 inches deep and 21 lbs.
PowerWave technology delivers chest-pounding bass and crystal-clear highs. It also features hum-free noise floor and ultra-low distortion of .03 THD. To keep the PLX running under the most demanding conditions, QSC has added their Advanced Thermal Management System. The PLX offers the reliability of a company that’s been building professional amplifiers for over 30 years.
 
Stereo mode/both channels driven: 8 ohms 20Hz-20kHz 0.03 THD/425W; 4 ohms 20Hz-20kHz 0.05 THD/700W; 2 ohms 1kHz 1 THD/1200W
Bridge mono mode: 16 ohms 20Hz-20kHz 0.1 THD/850W; 8 ohms 20Hz-20kHz 0.1 THD/1500W; 4 ohms 1kHz 1 THD/2400W
Signal to noise (20Hz-20kHz):<-106 dB
Input sensitivity @ 8 ohms: 1.0Vrms
Input sensitivity @ 4 ohms: 0.9Vrms
Voltage gain: 40x (32 dB)
Output circuitry: 2-StepClass H
Distortion (SMPTE-IM): less than 0.01
Distortion (typical): 20Hz-20kHz: 10 dB below rated power–less than 0.01 THD; 1.0kHz and below: full rated power–less than 0.01 THD
Frequency response: 20Hz-20kHz, +/- 0.2 dB/8Hz-50kHz, +0, -3 dB
Damping factor: greater than 500
Input impedance: 6K ohms unbalanced, 12K ohms balanced
Input clipping: 10 Vrms (+22 dB)
Cooling: variable-speed fan, rear-to-front air flow
Input: 3-pin XLR 1/4-in. TRS balanced
Output: Neutrik Speakon(TM) and touch-proof binding posts
Amplifier protection: full short circuit, open circuit, thermal, ultrasonic, and RF protection
Load protection: on/off muting, DC-fault power supply shutdown